13—Operating the Hard Disk Recorder
Roland VS-2400CD Owner’s Manual www.RolandUS.com 179
After the VS-2400CD previews the audio starting at the now line it sets Scrub to
play from the event and on.
13. Turn the Time/Value dial to set the now line so it’s the very start of the event.
14. Press SCRUB again to turn it off.
15. Place a locator (Page 179) or marker (Page 182) at the now line’s position—you can
use the locator or marker to move to this spot during track editing.
Setting Scrub Times
1. Hold down SHIFT and press F4•UTILITY.
2. If “PlyRec” isn’t displayed above F4, press PAGE until it is.
3. Press F4 (PlyRec).
4. Press F2 (Param2).
5. Set SCRUB LENGTH to the desired time, from 25 ms (milliseconds) to 100 ms.
6. Press F6 (EXIT) to confirm your changes.
Locators
The VS-2400CD can memorize up to 100 locations in a project, allowing you to jump to
any one of them instantly. This makes it easy to quickly get from place to place without
having to slow down to hunt for the desired location. Each place you want the
VS-2400CD to remember is stored in its memory as a “locator.” To jump to that place,
recall the locator and the now line instantly moves to its position in the project.
Locators are stored in ten locator banks, numbered from 0-9. Each bank can contain up
to 10 locators, also numbered 0-9. You can also name each locator to help remind you
where in the project it’ll take you—see “Editing Locators” on Page 180.
Basic Locator Operations
The following operations take place when the LOCATOR indicator is
lit to signify you’re in Locator mode.
It’s best to use locators to store the locations of sections of your project, as opposed to
the locations of individual audio events. Since locators are so easy to recall, they’re
great for getting around. For places you want to bookmark but don’t plan to visit often,
use markers (Page 182)—you can have up to 1,000 markers in project.
You can use the Locator feature’s Safe mode to perform locator
operations more carefully from list in a LOCATOR window. See Page 181.
The gray bar beneath the waveform
shows you what SCRUB FROM plays
VS2400OMUS.book 179 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
