Roland VS-2400CD - The ENTER;YES and EXIT;NO Buttons; The SHIFT Button; Using a Mouse

4—Setting Up and Basic Operations
68 www.RolandUS.com Roland VS-2400CD Owner’s Manual
The ENTER/YES and EXIT/NO Buttons
Use the ENTER/YES or EXIT/NO buttons beneath the to execute
or cancel the current operation, or to respond to a question posed
on the display.
The ENTER/YES and EXIT NO buttons blink to signify that you can press the:
• ENTER/YES button to finish, or press EXIT/NO to cancel, the current operation.
• ENTER/YES to answer “yes” to a displayed question, or EXIT/NO to reply “no.”
The ENTER/YES button also blinks to indicate that you can press it to view additional
options. EXIT/NO flashes at times to show you can press it to exit the current screen.
The SHIFT Button
Many of the VS-2400CD’s buttons perform more than one job—
these buttons often have an upper label and a lower label that’s
printed inside an outline box. The un-boxed label shows the
button’s primary function, the boxed label its secondary use.
To cause a button to perform its secondary job, hold down SHIFT and press
the button before letting go SHIFT.
Using a Mouse
The VS-2400CD uses a two-button mouse that can be set up for
right-handed or left-handed users, according to the setting of the
MOUSE BUTTON SWAP Sw System parameter in the
VS-2400CD’s UTILITY menu. When the parameter’s turned:
• off —the mouse operates as a right-handed mouse. The left
button clicks and the right button displays pop-up menus.
• on —the mouse operates as a left-handed mouse. The right button clicks and the left
button displays pop-up menus.
When the Owner’s Manual says to “click” the mouse, right-handed users should click
the left-hand button. When it says to “right-click,” they should click the right-hand
button. If you’re a left-handed mouse user, you’ll need to mentally reverse these
instructions—”click” the right-hand button and “right-click” the left-hand button.
You can tell the ENTER/YES button from the EXIT/NO simply by touch—ENTER/YES
is larger.
If you prefer, you can always use the Enter key on your keyboard instead of ENTER/
YES, or the Esc key instead of EXIT/NO.
You can set the SHIFT button so that it toggles on and off with each touch
to cut down on SHIFT-button presses. See “SHIFT LOCK” on Page 357.
Primary
function
Secondary
function
JUMP
+
=
VS2400OMUS.book 68 ページ ２００６年２月２８日 火曜日 午前１１時１２分