Roland VS-2400CD - The EZ ROUTING LOOP EFFECT ASSIGN Screen; Making Connections on the EZ ROUTING OUTPUT ASSIGN Screen; Making Connections on the LOOP EFFECT ASSIGN Screen

22—EZ Routing
280 www.RolandUS.com Roland VS-2400CD Owner’s Manual
On this screen, you can also configure the track direct outputs so that they’re pre-fader
or post fader (Page 275), and adjust your listening level using the REC ATT parameter
(Page 273) when you’re listening to the 16 recording busses instead of the MASTER
mix.
Making Connections on the EZ ROUTING OUTPUT ASSIGN Screen
1. Use  or  to select the desired pair of outputs.
2. Turn the Time/Value dial to create the desired connection.
Output routing is described in detail in Chapter 21. In addition, on Page 73, you’ll find a
detailed set of steps for setting up digital monitoring through a pair of Roland DS-90A
or DS -50A Digital Reference Monitors.
The EZ ROUTING LOOP EFFECT ASSIGN Screen
On the EZ ROUTING LOOP EFFECT ASSIGN screen, you can select the Aux or Direct
path that carries signals to each of the VS-2400CD’s internal effect processors. You can
also see a symbol for each processor’s currently selected effect patch.
Making Connections on the LOOP EFFECT ASSIGN Screen
1. Use  or  to select the desired internal effect processor.
2. Turn the Time/Value dial to select the desired Aux bus or Direct path.
The routing of Aux busses and Direct paths to the internal effects is discussed in detail
on Page 204.
For the purposes of routing, busses are treated as odd/even pairs that can include two
mono busses or one stereo bus. Tracks are also routed in pairs. Outputs are divided into
odd/even, left/right pairs as well. These pairs cannot be altered.
If you cursor all the way to the left, you’ll select the MONITOR bus assignment
junction. Turn the Time/Value dial to select the pair of busses—or stereo bus—you’d like
to send into the stereo MONITOR bus.
If an Aux bus is linked to its odd/even partner (Page 200), “L” and “R” are attached to
the end of their names.
Linked Aux busses are routed to an internal effect as a single stereo source.
Effect
processors
Busses
If there’s no optional
VS8F-2 effect expansion
board installed for an effect
processor, “No FX Board”
appears instead of an effect
patch symbol.
VS2400OMUS.book 280 ページ ２００６年２月２８日 火曜日 午前１１時１２分