Roland VS-2400CD - Multi-Channel View Input Channels

33—VGA Main Display Mixer Views
Roland VS-2400CD Owner’s Manual www.RolandUS.com 429
5. AUTOMIX STATUS Button
6. MASTER Bus Balance Knob
7. MASTER Bus Fader
8. DITHER
Multi-Channel View Input Channels
1. Input Signal Selector
2. PHASE (INV) Button
3. ATT Knob
4. DYNAMICS (DYN) Switch and Overview
5. EQ Switch and Overview
Click the AUTOMIX STATUS button to set the MASTER fader’s
Automix status when Automix is turned on.
Drag the MASTER bus balance knob up or down to shift the MASTER bus output right or
left, respectively.
Drag the MASTER bus fader up or down to set the level of the MASTER
bus—this is the same thing as moving the physical MASTER fader on
the VS-2400CD. The current MASTER bus level is shown beneath the
fader.
To activate output dithering, click and hold the DITHER button and
select the desired dithering bit depth.
Click the input signal selector to select the desired
input signal for the channel. Odd-numbered
inputs can be assigned to odd-numbered input
channels, and even-numbered inputs to even-
numbered input channels.
Click the PHASE button so it lights to reverse the
phase polarity of the input channel’s signal.
The ATT knob sets the level of the signal coming
into the channel as shown to the left of the knob.
Turn on the channel’s dynamics processor by clicking the DYN
switch so it lights. The selected type of dynamics processor is shown
beneath the switch along with the current dynamics curve.
Turn on the channel’s EQ by clicking the EQ switch so it lights. The
current EQ curve appears below the switch.
318
137
359
1.
4.
11.
12.
13.
14.
5.
7.
2.
3.
6.
8.
10.
9.
160
150
148
149
149
VS2400OMUS.book 429 ページ ２００６年２月２８日 火曜日 午前１１時１２分