Roland VS-2400CD - Performing Edits; The Appearance of Selected Tracks, Phrases and Regions; Configuring the Behavior of the IN, OUT, from and to Buttons

18—Editing Tracks
234 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Configuring the Behavior of the IN, OUT, FROM and TO Buttons
1. Hold down SHIFT and press F4•UTILITY.
2. If “GLOBAL” doesn’t appear over F2, press PAGE until it does.
3. Press F2 (GLOBAL).
4. The EDIT POINT Sw TYPE parameter sets the behavior of the IN, OUT, FROM and
TO buttons for resetting your IN, OUT, FROM or TO edit points. You can choose:
• Same as LOCATOR —so that pressing an edit point’s button moves the timeline
to the edit point’s location in the project.
• OVERWRITE —so that pressing an edit point’s button resets the edit point to the
current position of the timeline.
5. Press F6 (EXIT) to confirm your changes and to leave the GLOBAL Param1 screen.
Performing Edits
The Appearance of Selected Tracks, Phrases and Regions
Depending on the method you use to select a phrase or region in the playlist—we’ll
describe these methods later in this chapter—the process can have two steps:
1. Select the track on which the desired phrase or region resides.
2. Select the phrase or region.
When a track, phrase or region is selected, its appearance changes. When a track is
selected, a triangle appears to its left and the track turns white.
When a phrase or region is selected, it’s outline becomes dotted.
If EDIT POINT Sw TYPE is set to OVERWRITE, you can still move the timeline to an
edit point—hold down SHIFT and press the desired IN, OUT, FROM or TO button.
If you select audio on one of a pair of linked tracks, the audio on the other linked track
is also selected.
Track turns white
Triangle
Selected phrases Selected regions
When audio is selected, it has a dotted outline. If its
track is also selected, it’s white. If not, it’s black.
VS2400OMUS.book 234 ページ ２００６年２月２８日 火曜日 午前１１時１２分