7—Project and Drive Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 91
Project Operations
About F6 (MARK)
Before you can perform some of the project operations, you have to
target the project on which you want to perform the operation. You do
this by marking the project.
Marking a Project
1. Press
or
or turn the Time/Value dial to select the project.
2. Press F6 (MARK) to place a checkmark to the left of the project’s name, thus
targeting it.
SELECT
Press SELECT to load the project that’s currently highlighted in the
project list. When it’s loaded, it replaces the project that’s currently
stored in the VS-2400CD’s onboard memory. You can play, record, edit
and mix a project only while it’s loaded into the VS-2400CD.
To load a project from another drive, select the drive and press F6 (LIST), as described
in “To Display the Projects on a Drive” on Page 90.
Loading a Project
1. Hold down SHIFT and press F1 (PROJECT).
2. If “SELECT” isn’t visible above F1, press PAGE until it is.
3. In the project list, select the project you want to load.
4. Press F1 (SELECT). The VS-2400CD displays:
5. Press ENTER/YES to load the selected project, or EXIT/NO to cancel the operation.
If you pressed ENTER/YES, the VS-2400CD asks:
6. Press ENTER/YES to store your latest changes to the currently loaded project
before loading the new one, or EXIT/NO to skip re-saving it.
The VS-2400CD loads the selected project into its memory.
F6 (MARK) is available only when a project, not a drive, is selected.
The SELECT button doesn’t look quite like any other VS-2400CD menu button, and it
acts differently, too. It’s the only button that performs its action as soon as you press it.
All of the other buttons merely display the corresponding operation’s screens.
If the currently loaded project is write-protected (Page 95), the VS-2400CD loads the
new project without displaying this question.
VS2400OMUS.book 91 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
