28—Expanding the VS-2400CD
378 www.RolandUS.com Roland VS-2400CD Owner’s Manual
3. Turn the VS-2400CD over onto its back, and remove only the screws shown in the
following illustration.
4. The battery should now be visible, as shown here.
5. Remove the VS8F-2 for Effect B.
6. Replace the old battery with a new one.
7. Reinstall the effect expansion board (VS8F-2) removed in Step 5. Insert the plastic
pins into the VS8F-2’s holes, making sure the board is securely fastened in place.
8. Use the screws that you removed in Step 3 to re-fasten the VS-2400CD’s bottom
cover. This completes the process of exchanging the lithium battery.
9. Connect the cables that you disconnected earlier.
10. Turn on the power, as described in “Powering Up” on Page 63.
11. Confirm that the message saying the lithium battery is depleted no longer appears
in the display.
12. Hold down SHIFT and press F3 (EFFECT), and verify that effect patch symbols for
Effects 1 and 2 are visible. If they’re not, re-install the VS8F-2 card you removed in
Step 5 (see Page 373 for help).
13. Reset the VS-2400CD’s clock and calendar (Page 65).
The VS-2400CD uses a lithium CR2032 battery that you can purchase at most
electronics stores.
The VS-2400CD’s clock is powered by its battery. Changing the battery may stop the
clock or cause it to display the wrong time or date.
EFFECT A
Lithium Battery
EFFECT B
EFFECT A
Should you remove battery and
screws, make sure to put them
in a safe place out of children’s
reach, so there is no chance of
them being swallowed
accidentally.
VS2400OMUS.book 378 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
