7—Project and Drive Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 113
4. Press F1 (DrvChk). The VS-2400CD asks:
5. Press ENTER/YES to check the selected drive, or EXIT/NO to cancel.
The VS-2400CD asks if you want to save any recent changes to the current project.
6. Press ENTER/YES to save the project, or EXIT/NO to proceed to the Drive Check.
The Drive Check can take a while, depending on the size of your drive.
When the check is complete, the VS-2400CD displays a report of the results.
7. If errors have been found, press ENTER/YES to have Drive Check attempt to
remove the cause of the problem from your drive, or press EXIT/NO to cancel
Drive Check.
The VS-2400CD warns you: “You’ll Lose Data,” but, as noted above, any data Drive
Check wants to remove is probably unusable anyway.
8. Press ENTER/YES to proceed, or EXIT/NO to cancel the operation.
When Drive Check has finished its repair, it displays what it’s done. Projects that’ve
been partially altered are indicated by “Alt,” and projects that have been completely
deleted are shown as “Del.”
You can cancel the Drive Check at any time by pressing EXIT/NO. Do not interrupt
Drive Check by turning off the VS-2400CD’s power.
If you’re concerned about the risks of proceeding and would like some guidance, give
our Product Support team a call at 323-890-3740, x3741 from 8:30am to 5pm PST,
Monday-Friday.
Selected drive
VS2400OMUS.book 113 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
