EasyManua.ls Logo

Roland VS-2400CD - Page 159

Roland VS-2400CD
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11—Input and Track Channel Tools
Roland VS-2400CD Owner’s Manual www.RolandUS.com 159
4. Interactive EQ Display
The interactive EQ display shows you the settings of the four EQs. Each equalizer is
represented by a triangle.
You can change a band’s gain and frequency values on the interactive EQ display with
your mouse by dragging its triangle:
left or right to lower or raise, respectively, change its frequency.
down or up to lower or raise, respectively, its gain.
5. Low Band EQ
The Low EQ band operates on all frequencies below the selected
frequency. It has a:
frequency selector
—that sets the center frequency, from 20 Hz to 1.00 kHz.
gain control
—that raises or lowers the level of the selected frequency range. It can
be set anywhere from -15.0 dB to 15 dB.
The low band EQ is a shelving-type EQ that affects the level of all frequencies below
the selected frequency, as well as a narrow range of frequencies slightly above it. As
such, it requires no Q setting.
6. Lo-Mid Band EQ
The Lo-Mid EQ band is a parametric EQ that contains a:
frequency selector
—that sets the center frequency, from 20 Hz to 20.0 kHz.
gain control
—that raises or lowers the level of the selected frequency
range. It can be set anywhere from -15.0 dB to 15 dB.
Q
—that sets the width of the affect range of frequencies, from 0.36 to 16.0.
7. Hi-Mid Band EQ
The Hi-Mid EQ band is a parametric EQ that contains a:
frequency selector
—that sets the center frequency, from 20 Hz to 20.0 kHz.
gain control
—that raises or lowers the level of the selected frequency
range. It can be set anywhere from -15.0 dB to 15 dB.
Q
—that sets the width of the affect range of frequencies, from 0.36 to 16.0.
Although this EQ is called the “Lo-Mid” band, its wide range of frequency values
means that you can use it to adjust the level of any frequencies in a signal, low
or
high.
Although this EQ is called the “Hi-Mid” band, its wide range of frequency values
means that you can use it to adjust the level of any frequencies in a signal, high
or
low.
High bandLow band Lo-Mid band Hi-Mid band
The dotted vertical
lines help you see
where you are as
you drag a triangle.
Gain
Frequency
VS2400OMUS.book 159 ページ 2006年2月28日 火曜日 午前11時12分

Table of Contents

Other manuals for Roland VS-2400CD

Related product manuals