Roland VS-2400CD - Page 193

14—Working with Track Channels
Roland VS-2400CD Owner’s Manual www.RolandUS.com 193
3. Use  ,  ,  and/or  to select a source track channel’s output along the upper
edge of the TRACK MIXER block. We’ve selected Track Channel 1’s output in the
illustration on the previous page.
4. Turn the Time/Value dial clockwise—as you turn it, a wire appears that connects the
track channel to one track after another in the RECORDING TRACKS block.
5. Turn the dial in either direction to select the desired destination track.
6. To break the connection between a track channel and a track, repeat Steps 3 and 4,
and turn the Time/Value dial counter-clockwise until no connection exists.
7. Repeat Steps 3-5 to route other track channels’ outputs to the destination track.
To clear all track-to-track connections, press PAGE until “ClrTrA” appears above F4,
and then press F4 (ClrTrA).
We’ve selected linked
stereo Tracks 9 and
10 as our destination.
We’ve connected a
combination of mono and
stereo source track channels
to our stereo destination
linked tracks.
Source Tracks 1 and 16 are
mono track channels, and
Track Channels 23 and 24
are linked in stereo.
VS2400OMUS.book 193 ページ ２００６年２月２８日 火曜日 午前１１時１２分