16—Using Effects
Roland VS-2400CD Owner’s Manual www.RolandUS.com 221
To Configure the RSS Pan Feature:
1. Hold down SHIFT and press F4•UTILITY.
2. Press PAGE repeatedly until “RSSPan” appears above F2.
3. Press F2 (RSSPan)—the RSS PAN SETUP screen appears:
4. Cursor to the Use EFFECT Board parameter and turn the Time/Value dial to select
the effect board you’d like to use for producing the RSS Pan effect. You can select
Off—for no RSS Pan—or VS8F-2 A or B.
5. Press ENTER/YES to confirm your selection.
6. If you’d like to hear RSS Pan in your PHONES jack, turn the PHONES Sw on.
7. To select the first channel to which you’d like to apply RSS Panning. cursor down to
the top line in the USE CHANNEL LIST box and turn the Time/Value dial to select
the desired input or track channel.
8. To send additional channels’ signals to the RSS Pan effect, cursor to the other lines
in the Use CHANNEL LIST box and turn the Time/Value dial to select the desired
channel or channels.
You can use the B effect board only if your VS-2400CD has two VS8F-2s installed.
VS2400OMUS.book 221 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
