34—VGA Main Display EZ ROUTING Screen
438 www.RolandUS.com Roland VS-2400CD Owner’s Manual
Input to Input Channel Mouse Routing
Input signal to input channel routing occurs in the EZ ROUTING PATCH BAY pane.
To make a new connection:
1. Position the mouse cursor over the desired input channel pair until the cursor
changes to a pointing finger.
2. Click and drag the mouse to the desired pair of input jacks or connectors—a virtual
cable appears onscreen to show the connection you’re making, as shown above.
To change or delete an existing connection:
1. Position the mouse cursor over the desired input channel pair until the cursor
changes to a pointing finger and click once.
2. Position the mouse cursor over the desired input jack or connector pair until the
cursor changes to a pointing finger.
3. Click and drag the mouse left or right to select a new input channel pair or all the
way to the left to delete the connection.
Routing Signals to a Recording Track Using a Mouse
The procedures for routing a signal from an input channel, track channel, FX return
channel, Aux bus, Direct path or generator (Page 366) to a recording tracks are the
same, and take place in the TRACK ASSIGN EZ ROUTING pane.
To make a new connection:
1. Position the mouse cursor over the connection node you want to route to the track.
2. Click and drag the mouse to the desired recording track—a virtual cable appears
onscreen to show the connection you’re making.
VS2400OMUS.book 438 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
