Sam4s SPS-300 - Page 145

SAM4S SPS-300 Series Electronic Cash Register AU Service Mode Programming • 133
When the function key you want appear on the display, type the key code number you wish to
place and the screen returns to the KEY ASSIGNMENT screen then press ENTER (CASH).
4. The KEY ASSIGNMENT screen displays again, with additional info “PRESS CASH TO
EXIT”. Press CASH as Enter to exit.
5. Press the ENTER (CASH) key to finalize current function key assignment, or ESC
(CLEAR) key to cancel the programming.
6. The current function key assignment is finished. The screen go back to SM Mode. If more
function keys are about to be assigned, repeat the procedure from Step 1.
NOTE 1: Numeric keys (0-9), CLEAR/ESC, and CASH/ENTER cannot be removed from
the keyboard unless they have been assigned to a new keyboard location. This
protects the programmer from accidentally removing keys that are required for
register programming and operations.
NOTE 2: If you wish to program the CASH/ENTER key, select it immediately after
selecting KEY ASSIGNMENT from the SERVICE MODE menu. After the
initial key is programmed, the CASH/ENTER key is used to finalize the program.
SERVICE MODE
È
0.H/W TEST
1.CLEAR ALL TOTALS
2.CLEAR GRAND TOTAL
3.CLEAR PLU FILE
4.FLASHROM INFORMATION
5.MEMORY ALLOCATION
6.KEY ASSIGNMENT
KEY ASSIGNMENT
KEY NUMBER : 337
CURRENT ASSIGNMENT
CONV1
ENTER NEW CODE,
PRESS CASH
3
79 Å
KEY ASSIGNMENT
PRESS CASH TO
SAVE CHANGES
OR
PRESS ESCAPE TO EXIT
WITHOUT SAVING
KEY ASSIGNMENT
PUSH KEY TO BE
PROGRAMMED
PRESS CASH TO EXIT
0
Å