Sam4s SPS-300 - Memory All Clear

SAM4S SPS-300 Series Electronic Cash Register AU Service Mode Programming • 121
Memory All Clear
Before you use your SPS-300 Series Electronic Cash Register for the first time, you must perform a
Memory All Clear to insure that all totals and counters are cleared and that the factory default
program is installed.
CAUTION: The procedures described in this area are security sensitive. Clearing all or parts of
the memory may cause damage or loss to the program. Do not share this
information with unauthorised users and distribute the special SERVICE-Mode
key only to those you may want to perform these functions.
Perform "Clear All Totals", or "Clear PLU File" if you wish to clear only parts of memory.
Complete clearing of all memory areas and installation of the default program can be done through
the following special procedure:
Memory All Clear (RAM All Clear)
To Perform a Memory All Clear (reset memory completely)
1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the S position (one past PGM position, a hidden position).
3. For SPS-320/340 (150 key Flat keyboard Models)
Press and hold the key position where the CHECK key is located on the default
keyboard layout.
For SPS-325/345 (98 key Raised keyboard Models
Press and hold the key position where the SUBTOTAL key is located on the default
keyboard layout.
↑ SPS-320/340 ↑ SPS-325/345
4. Continue to hold the CHECK button while turning the power switch to the ON position.
5. After the BEEP, release the CHECK button, RAM ALL CLEAR will appear on the
display.
RAM ALL CLEAR