Sam4s SPS-300 - Not Found PLU Function; Enter Not Found PLU Programming; Quick Entry

54 • Operating Instructions SAM4S SPS-300 Series Electronic Cash Register AU
Not Found PLU function
The “Not Found PLU” feature is used when a new item which is not yet been programmed is
registered. When the operator decided to register that item, choices between Quick Entry, input the
price of the item and assign it the same descriptor and properties of another PLU, or Detail Entry,
enter the descriptor and tax status independently are available. This provides a simple mechanism for
building a PLU file.
Program descriptions by typing description on the alpha keyboard overlay is default. To
program description by three digit character codes, you must select Program Mode Programming
Æ System Option Programming Æ pg 17 (page 17) Æ PROGRAM DESCRIPTOR BY CODE
sets Y. Also see Descriptor Programming Methods for Alpha Overlay and/or Descriptor Code
Table.
Enter Not Found PLU Programming
1. After scanning or entering a PLU not in the PLU file, the screen below will appear on the
display, along with warning beeping. Press CLEAR button to start Not Found PLU
Programming procedure.
There are two ways to program a new PLU, Quick Entry and Detail Entry. Please read on for
instruction for both methods.
Quick Entry
1. On the NOT FOUND PLU PROGRAM screen appears like below. Press 1 to start Not
Found PLU Entry Procedure (or press 0 to Stop (discard the registration of the item)).
NOT FOUND PLU PROGRAM ?
0 : NO 1 : YES
CLEAR
NOT FOUND PLU PROGRAM ?
1