Sam4s SPS-300 - Machine no; Training Mode Password

SAM4S SPS-300 Series Electronic Cash Register AU Program Mode Programming • 263
Machine No.
The machine number is printed on the register receipt. Program a machine number so that any receipt
can be identified with the store or register where the transaction took place. The machine number may
be a different number than the IRC register number programmed in IRC programming (See Service
Mode Æ 7.IRC OPTIONS for detail.)
1. From the PGM control lock position menu, press 00 for MORE. The PROGRAM MODE
page 2 screen displays. Press PAGE DOWN to view the remainder of the page 2 program
options.
2. From the PROGRAM MODE page 2 screen, press 7 for MACHINE NO. The MACHINE
# PROG. screen displays:
3. Type the machine number, up to 5 digits, press ENTER (CASH).
Training Mode Password
If you wish to use training mode, you must program a password that you will use to enter training
mode. The password may be up to 4 digits long, however, if you choose to use a password less that
for digits, you must enter preceding zeros to complete a 4 digit entry. For example, if you program the
password to be "77", you must type "0077" when entering training.
1. From the PGM control lock position menu, press 00 for MORE. The PROGRAM MODE
page 2 screen displays. Press PAGE DOWN to view the remainder of the page 2 program
options.
2. From the PROGRAM MODE page 2 screen, press 9 for TRAINING MODE P/W. The
TRAINING MODE P/W screen displays:
3. Type the password, up to 4 digits, press ENTER (CASH).
TRAINING MODE PASSWORD
PASSWORD : 0
Å
MACHINE # PROGRAM
MACHINE # 0
Å