Sam4s SPS-300 - Editing an Existing Macro

262 • Program Mode Programming SAM4S SPS-300 Series Electronic Cash Register AU
Editing an Existing Macro
1. After selecting a macro to program the screen displays the keystrokes currently programmed.
2. Press the YES/NO key to advance the cursor to the line you wish to edit.
3. With the cursor pointing at a line, press (or select) the new function you wish to place in the
macro sequence.
4. If you wish to remove a key stroke from a macro, replace the current function with the
INACTIVE function by pressing the PAGE DOWN to display a keycode list, then enter
1 9 9.
1. ONE Å
2. TWO
3. THREE
4. FOUR
5.
6.
7.
8.