Sam4s SPS-300 - RS232 C Settings Screen Program Notes

138 • Service Mode Programming SAM4S SPS-300 Series Electronic Cash Register AU
RS232C Settings Screen Program Notes
Page Field Description
1 BAUD RATE
Select proper baud rate from the list. COM#1 defaults to 6
(57600), COM#2~#4 default to 0 (9600).
PARITY
Select between 0 (NONE), 1 (EVEN), or 2 (ODD) from list.
0 (NONE) is default.
DATA BITS
Select 0 (8) or 1 (7) from the list. 0 (8) is default.
2 STOP BITS
Select 0 (1) or 1 (2) from the list. 0 (1) is default.
DEVICE FUNCTION
Enter the number represents the device you wish to attach to
this port from the list. COM#1 and #4 default to 1 (PC),
COM#2 and #3 default to 0 (NONE)
Some device function has related feature to select as well:
2 (SCL - Scale) Æ SCALE TYPR (pg4)
3 (RJ - Remote Journal) Æ PRINTER TYPE (pg4 - 7)
4 (RP - Remote Printer) Æ PRINTER TYPE (pg4 - 7)
8 (EFT - EFTPOS) Æ EFT TYPE (pg8) (not for AU
market)
9 (POLE - Pole Display) Æ POLE DISPLAY TYPE
(pg8)
3 INITIAL FEEDING LINE ON
KP (0-20)
Enter the number as the number of lines will be advanced
before the content of KP starts to print when a external
printer (RP - Remote Printer) is used.
ENDING FEEDING LINE ON
KP (0-20)
Enter the number as the number of lines will be advanced
after the content of KP has been printed when a external
printer (RP - Remote Printer) is used.
INITIAL FEEDING LINE ON
SLIP (0-20)
Enter the number as the number of lines will be advanced
before printing starts on a new slip when a slip printer is
used..
4 PRINT LINE ON GUEST
CHECK (0-50)
Enter the number of lines that represent the maximum that
can be printed on a single guest check.
SCALE TYPE
When DEVICE is 2 (SCL), select the scale protocol by enter
the number represent the interface on this port.
4 ~ 7 PRINTER TYPE
When DEVICE is 3 (RJ) or 4 (RP), select the printer driver
by enter the number represent the printer model on this port.
8 POLE DISPLAY TYPE
When DEVICE is 9 (POLE), select the pole display protocol
by enter the number represent the protocol on this port.
EFT TYPE
Select the digit that represents the EFT type connected to this
port.