58 • Operating Instructions SAM4S SPS-300 Series Electronic Cash Register AU
6. The new item is registered with the description and price entered, and tax status selected.
NOTE: All Not Found PLUs are default to link to Group 1.
Not Found PLU Report
For better management, there is a Not Found PLU Report (8.NOT FOUND PLU) in X
(Manager) Mode and Reset Not Found Report (7.RESET NOT FOUND PLU) in Z
(Reset Report) Mode. This report is an independent report from normal PLU report. All
newly added PLUs through Register Mode will update into Not Found PLU Report and
PLU Report. When perform the Reset Not Found PLU Report, the current report will still
print then reset the report.
NOTE: Up to 50 Not Found PLU items can be retained. When capacity is reached, any
further registration of new Not Found PLUs will not be recorded, along with **
WARNING ** NOT FOUND FULL! error message. you must run Not Found
PLU report in Z-Mode to print and clear the report. Despite the failure of recording
those Not Found PLUs into the report, those PLUs are still recorded into register’s
PLU memory. And are able to be registered later.
On FlashROM v01.011 and later, the PLU descriptor will also print on the report if
programmed. A sample report is below. Notice the item name programmed is “COKE ORIG
350 BOTT” (18 digit characters in full) but only the last 14 digit characters “ ORIG 350
BOTT” is shown.
Report Example :
DATE 01/05/2012 TUE TIME 08:30
NOT FOUND PLU LIST
PLU#12345678901234 ORIG 350 BOTT
CLERK 1 No.000011 00001
Modify a Programmed Not Found PLU
When a Not Found PLU is added through Quick Entry or Detail Entry, if a further
programming is needed, you can complete the programming or re-program a Not Found
PLU via Program Mode Programming Æ 0.PLU Æ 0.ADD/MODIFY PLU, just enter the
PLU number of the PLU you want to program according to the Not Found PLU Report,
then press PLU function key, you will be able to access that PLU’s information.
REGISTER MODE
1 B.L.T BURGER T1 7.95
TAX 0.00 SUBT 7.95
To Next Page
Loading...
