Sam4s SPS-300 - Page 189

SAM4S SPS-300 Series Electronic Cash Register AU Program Mode Programming • 177
Page Field Value Description
12 RESET GST AFTER
SERVICE ON HARD CHECK
Y or N Select Y to enable resetting GST on the Hard Check just
serviced to avoid GST amount been incorrectly cumulated.
ROUNDING ON SUBTOTAL
Y or N WARNING: By law, the rounding is only apply to CASH
transaction. Please check with authority before changing this
option.
Select Y to execute rounding when SUBTOTAL is pressed.
The “ROUNDING ON CASH” has to set to N.
ROUNDING ON CASH
Y or N WARNING: By law, the rounding is only apply to CASH
transaction. Please check with authority before changing this
option.
Select Y to execute rounding when CASH is pressed. The
“ROUNDING ON SUBTOTAL” has to set to N.
13 PRICE LEVEL IS
0:POP UP AFTER ITEM
1:POP UP AFTER SALE
2:STAYDOWN
0
If you press a price level key, you have the option of the
level key applying only to the next item (0), having the same
level key apply to any subsequent item registered in the same
transaction (1), or having the same level key apply to any
subsequent item on any subsequent transaction(2).
ELECTRONIC JOURNAL
Y or N Select Y to enable the electronic journal. The electronic
journal captures in memory what you would print line by line
on a traditional journal. The four options that follow control
the electronic journal feature. The electronic journal can be
read and printed in the X control lock position or reset and
printed in the Z control lock position.
14 PROMPT OPERATOR
WHEN EJ BUFFER IS FULL
Y or N If the electronic journal is enabled above, select Y if you
wish to display a message to notify the operator when the
journal memory is full.
STOP OPERATIONS WHEN
EJ BUFFER IS FULL
Y or N If the electronic journal is enabled above, select Y if you
wish to stop operations when the journal memory is full.
SEND ONLY NEGATIVE
ENTRIES TO EJ
Y or N If the electronic journal is enabled above, select Y if you
wish to capture only transactions with negative entries.
X REPORT AND
DECLARATION SEND TO
EJ
Y or N If the electronic journal is enabled above, select Y if you
wish to capture X report and declaration.
15 SEND RESET REPORT TO
EJ
Y or N If the electronic journal is enabled above, select Y if you
wish to capture reset reports.
DIRECT MULTIPLICATION
MORE THAN ONE DIGIT
Y or N
If you allow direct multiplication of a preset PLU, you can
allow only single digit multiplication or multiplication by
more than one digit.
TENDER VALIDATION
Y:AMT TENDERED
N:AMT OF SALE
Y or N
Validation is allowed if an appropriate optional printer is
connected to an RS-232C port. Here you can choose the
content of single line validation
16 ROUNDING SYSTEM
Y or N Select Y to enable Rounding System.
Rounding Rates
Enter the high amount of the first range where you are
prompted. The low amount of the next range will be
computed automatically.