Sam4s SPS-300 - Page 220

208 • Program Mode Programming SAM4S SPS-300 Series Electronic Cash Register AU
CHECK # Key Function Options
Page Field Value Description
1
DESC
Alpha
numeric up
to 12
character
You can program a descriptor. The default descriptor is
CHECK #.
NOTE: You may wish to use TABLE # as the description.
KEY DISABLE
Y or N Select Y to disable this function.
COMPULSORY FOR ALL
SALES
Y or N Select Y you must begin a new, or recall an existing tracking
number before registering items.
OPENING CLERK HAS
EXCLUSIVE ACCESS
Y or N If Y, the clerk that begins a tracking number is the only clerk
who can recall a check. If N, any clerk can recall any check.
PRINT ON RECEIPT
Y or N If N, the check track number and balance will not print on
the receipt.
2
PRINT ON REMOTE
Y or N If N, the check track number and balance will not print on
the remote.
ALLOW ONLY ONE CHK
PER TABLE
Y or N
If Y, you can begin only one check with the same table #.
CHECK # ASSIGNED BY
REGISTER
Y or N If Y, press the CHECK. # key to automatically assign the
next sequential check. Check numbers will begin with #1
and continue until the open check report is reset, at which
point the check number will be reset and start at #1 again.
DRIVE THRU FEATURE
ENABLED
Y or N
If you wish to implement a drive thru recall key, this setting
changes the function of the PBAL key to that of a recall key.
Press the PBAL key directly to automatically recall the open
check with the lowest tracking number
3
LENGTH OF CHECK
(0-9, 0 : NO LIMIT)
0
Set the length of check in number of digits. For example, if
4, then checks must be used in the range from 1000, to 9999.
This setting applies only to check numbers input by the
operator, not to check numbers assigned by the register.
SCAN CHECK #
Y or N Choose Y to allow the check number to be input by a
scanner (must be nine digits or less).
SHARE CHECK FILE
Y or N Choose Y to allow share check file within IRC network. See
SM-Mode, 7.IRC OPTIONS for related settings.
PRINT CHECK TO THE
SERVER
Y or N Choose Y to allow printing Guest Check to the Server
Register. See SM-Mode, 7.IRC OPTIONS for related
settings.
PRINT CHECK TO THE
SATELLITE
Y or N Choose Y to allow printing Guest Check to the Satellite
Register. See SM-Mode, 7.IRC OPTIONS for related
settings.