Sam4s SPS-300 - Page 228

216 • Program Mode Programming SAM4S SPS-300 Series Electronic Cash Register AU
To Program Function key Status in Function Lookup
1. Press 1 to program the options for a function on the function look-up key, the function
key list of FUNCTION LOOKUP #1 key screen displays:
2. Press the number represents the function key you want to modify. The function key status
screen will then displays.
3. If you are programming function key options, refer to each function separately in this
chapter to set function options.
4. Press ESC (CLEAR) to go back to FUNCTION LOOKUP #1 key list screen for
different function key, or press ESC (CLEAR) key a second time to return to the
PROGRAM MODE menu.
1. CANCEL
2. MDSE RETURN
3. RA1
4. PO1
5. TIP
6. TAXEXMT
7. CONV1
8. TIME IN
/
OUT