Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-61
3.16 SERVICE MODE (Cont’d)
DISPENSE or TEAR OFF OFFSET MODE
Menu Description
Adjusting the stop positions of four GAP sensors for dispense or tear off. The
number beside GAP shows the position of the GAP sensor, ascending from the
center to the right of the printer.
Use + / - buttons to change the value.
“+”: Moves stop position forward to feed direction.
“-”: Moves stop position backward to feed direction.
Setting range is ±0 - 72dot.
The default setting is “+00dot”.
Press FEED to proceed to each GAP sensor to complete the settings.
Adjusting stop position of I-MARK sensor for dispense or tear off.
Use + / - buttons to change the value.
“+”: Moves stop position forward to feed direction.
“-”: Moves stop position backward to feed direction.
Setting range is ±0 - 72dot.
The default setting is “+00dot”.
Press FEED to save the setting and return to service mode menu.
To Next Page
Loading...
