SATO HR2 Series - Turning on the Power; Turning off the Power

Section 2: Installation
Page 2-20 HR2 Series Operator Manual
2.6 BASIC CONNECTIONS (cont’d)
2.6.5 Turning On the Power
Turn on the power switch located on the front, bottom left
corner of the printer.
Press the side of the switch marked “I”.
• When you turn on the power, the printer start-up and
detect for the loaded media and ribbon. If the media are
correctly loaded, “ONLINE” appears on the display.
• If the media and carbon ribbon are not loaded or prop-
erly loaded, the printer will prompt an error message.
Load the media and carbon (refer to Section 2.3 Load-
ing Media and Section 2.4 Loading the Carbon Rib-
bon) and then press LINE button.
2.6.6 Turning Off the Power
When you have completed the printing job, turn the printer
off.
1. Press the LINE button to put the printer offline.
Be sure to confirm that the printer is in the offline status
before turning it off.
If there is any printed media remaining in the printer,
press FEED button to forward feed the media and cut it
off.
2. Turn off the power switch on the printer’s operation
panel.
Press the side of the switch marked “O”.
Warning
Do not operate the power switch or insert/remove the power cable while your hands are wet.
Doing so may cause an electric shock.
On Off
On
Off