Section 7: Interface Specifications
HR2 Series Operator Manual Page 7-1
INTERFACE SPECIFICATIONS
This section presents the interface types and their specifications for the HR2 series printers. These
specifications include detailed information to assist in the selection of the most appropriate method for the
printer to interface with the host.
The following information is presented in this section:
• 7.1 Interface Types
• 7.2 RS232C High Speed Serial Interface
• 7.3 Universal Serial Bus (USB) Interface
• 7.4 Local Area Network (LAN) Ethernet
• 7.5 External Signal Interface (EXT)
7.1 INTERFACE TYPES
HR2 series printers are equipped with multiple interfaces to perform data communication with the host, an
external signal interface to connect peripheral devices to the printer, and an interface to connect a keypad to
the printer.
The following built-in interfaces are available.
1) RS-232C interface (can be used for Keypad)
2) USB interface
3) LAN interface
4) External signal interface (Amphenol 14 pin-female)
Caution
• Never connect or disconnect interface cables (or use a switch box) with power applied to either
the host or printer. This may caused damage to the interface circuitry in the printer/ host and is
not covered by warranty.
To Next Page
Loading...
