SATO HR2 Series - Service Mode Operations

Section 3: Operation and Configuration
Page 3-56 HR2 Series Operator Manual
3.16 SERVICE MODE
In SERVICE MODE menu, you can program various dimensional settings of the printer. Press <, > arrow
buttons to select SENSOR LEVEL, PITCH, OFFSET, BACKFEED or SETTING, and then press FEED button
to enter to the selected mode. Refer to the following flowcharts of the all setting and LCD display menus
available in SERVICE MODE.
3.16.1 Overview of Sensor Level adjustment in Service Mode
Return to
SERVICE MODE
menu
FEED button
* Press <, >, + or - button to select item or
set the value accordingly. The active icons
are displayed on the screen.
* Press and hold LINE button on each
screen will revert to SERVICE MODE
menu.
Select SENSOR LEVEL
+ FEED button
FEED button
LINE button
or
button
FEED button
or
button
LINE button
LINE button
LINE button
+
-

+
-
+
-

+
-
+
-
or
button
+
-
or
button
or
button
FEED button
LINE button
FEED button
LINE button
FEED button
LINE button
+
-
+
-
+
-
+
-
FEED button
FEED button
FEED button
FEED button
FEED button