SATO HR2 Series - Printer Language

Section 6: Basic Specifications
HR2 Series Operator Manual Page 6-3
Paper setting position Drop-in position, Center position after loading the label roll on the holder
RIBBON (Be sure to use ribbon manufactured or certified by SATO)
Width Max. 65 mm (2.55")
Length Max. 150 m (492.1ft.)
Wind Direction Face-In
Winding Method Wind on roll (Roll inner diameter: φ1", supporting paper roll only)
Max Roll outer diameter 51 mm (2.0")
PROCESSING
CPU 32 Bit RISC-CPU
Flash ROM 32 Megabytes
SDRAM 16 Megabytes
Communication buffer Max. 2.95 MB (Near full 2 MB)
External memory SD card (1 GB / Max 2 GB recommended)
PRINTER LANGUAGE
Standard SATO Barcode Printer Language (SBPL)
INTERFACES
Interface
(1) USB 2.0
(2) LAN (10BASE-T/100BASE-TX Auto detection)
(3) RS-232C (DSUB9 pin-female)
*For data transmission or connection to the SATO Keypad
(4) EXT Port (Amphenol 14 pin-female)
(5) SD card slot (1 slot)
SENSING
Gap (Transmissive) Sensitivity Adjustable
I-Mark (Reflective) Sensitivity Adjustable
Cover Open Fixed
Dispense Position Adjustable
Ribbon End Fixed
Rewinder Full Fixed
Head Lift Fixed
SELF-DIAGNOSIS FUNCTION
(1) Thermal head burnout check
(2) Paper end detection
(3) Ribbon end detection
(4) Cover open detection
(5) Test print
(6) Re-winder full detection
(7) Head Lift detection
MEDIA (Be sure to use media manufactured or certified by SATO)