SATO HR2 Series - Enabling Interface Card Configuration

Section 3: Operation and Configuration
Page 3-18 HR2 Series Operator Manual
3.7 INTERFACE MODE (Cont’d)
3.7.2 Enabling Interface Card Configuration
After selecting the interface for the Data port or Sub port, the next display shows the selected interface to be
configured. Refer to the following flowcharts of all the setting and LCD display menus available for LAN, RS-
232C and USB interfaces.
Setting of LAN
FEED
button
LINE
button
Select MANUAL
+ FEED button
LINE
button
FEED
button
LINE
button
FEED
button
LINE
button
FEED
button
LINE
button
FEED
button
LINE
button
FEED
button
LINE
button
FEED button
LINE
button
From DATA PORT
or SUB PORT
screen
Displayed only
when STATUS5
is set
Displayed only
when STATUS4
is set
Proceed to INTERFACE
MODE menu or
EXTERNAL DEVICE
screen
* Press <, > , + or - button to select item or set the
value accordingly. The active icons are displayed on the
screen.
* Press and hold LINE button on each screen will revert
to INTERFACE MODE menu.
0$18$/
,35(62/87,21
'+&3
0(7+2'
Select ENABLE
+ FEED button
LINE
button
FEED
button
LINE
button
Select DHCP +
FEED button
+
-
+
-
+
-
+
-
+
-
FEED button
Select DISABLE
+ FEED button