SATO HR2 Series - Hex Dump Mode

Section 3: Operation and Configuration
Page 3-34 HR2 Series Operator Manual
3.11 HEX DUMP MODE
HEX Dump Mode allows you to print the contents of the receive buffer in a hexadecimal format to allow the
data stream to be examined for errors and troubleshooting.
When HEX DUMP MODE is displayed, press the FEED button to enter to HEX Dump mode.
Note:
PASSWORD may prompt on the display if SET PASSWORD is set to ON in the Service mode. Please
refer to Section 3.16.5 Overview of Setting menu in Service Mode for details in password inputting.
HEX DUMP MODE
Menu Description
Selecting the data for printing HEX dump.
RECEIVE DATA: Printing the HEX dump of received data.
RECEIVE BUFFER: Printing the HEX dump of received print data (1 item
worth).
INTERNAL DATA: Printing the setting value for internal buffer.
The initial value is RECEIVE DATA.
Note that RECEIVE BUFFER cannot be selected when there is no received
data.
During HEX Dump Mode, the icon is displayed in the ONLINE/OFFLINE
screen.
FEED button
FEED
button
LINE
button
Displayed only when entry
of PASSWORD is enabled
* Press <, >, + or - button to select
item or set the value accordingly.
The active arrow icons are displayed
on the screen.
+
-
+
-
FEED button
FEED
button
LINE
button
HEX dump print
Executing HEX dump
print of receive data
Select RECEIVE BUFFER + FEED
button/INTERNAL DATA + FEED button
LINE button
Displayed only when entry
of PASSWORD is enabled
FEED button
HEX dump print
Select RECEIVE DATA +
FEED button
* Press <, >, + or - button to select
item or set the value accordingly.
The active arrow icons are displayed
on the screen.
+
-
+
-
icon is displayed when
RECEIVE BUFFER is selected.
icon is displayed when
INTERNAL DATA is selected.
For internal buffer Hex dump
printing and internal buffer data
printing, the screen automatically
changes to normal mode after
issuing the label.
After issuing the label