SATO HR2 Series User Manual

Section 3: Operation and Configuration
Page 3-60 HR2 Series Operator Manual
3.16 SERVICE MODE (Cont’d)
3.16.3 Dispense or Tear off offset adjustment in Service Mode
This is a fine tuning added on to the Offset position set in Adjustment mode or Test Print mode.
1. When OFFSET is selected, press the FEED button repeatedly will switch to the next setting options as
shown above. To return to the previous setting option, press LINE button. To return to SERVICE MODE
screen, press and hold LINE button.
2. When the desired setting option is displayed, press + / - buttons to set the value and then press FEED but-
ton to save the setting.
FEED button
Select OFFSET + FEED
button
LINE button
2))6(7
+
-
+
-
+
-
+
-
+
-
FEED button
LINE button
FEED button
LINE button
FEED button
LINE button
FEED button
LINE button
* Press <, >, + or - button to select
item or set the value accordingly.
The active icons are displayed on
the screen.
* Press and hold LINE button on each
screen will revert to SERVICE
MODE menu.
Return to SERVICE MODE menu

SATO HR2 Series Specifications

General

Brand	SATO
Model	HR2 Series
Category	Printer
Language	English