SATO HR2 Series - Explanation of the Contents of each Piece of Factory Test Print 2

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-43
3.13 TEST PRINT MODE (Cont’d)
3.13.3 Explanation of the contents of each piece of Factory Test Print 2
Factory test print enables to print out the printer setting.
Printed contents are subject to change without notice and the value depends on individual settings.
The printer setting will be printed on four pages.
1)First page --
Item name (Print) Item name Description
Model Name Model Name Printing the printer's model name.
Firm Version(Font
Ver)
Firmware version
and font version
41.xx.xx.xx(xx.xx(R))
Font version is Kanji font version shown in the table.
Font version is not included in CODE39 barcode.
Firm Date Firmware creation
date
YY.MM.DD
(The last two digits of the year, month, and date)
S/N
Printer’s serial No. xxxxxxxx
CONT S/N CONT PCB’s serial
No.
xxxxxxxx
PCB Rev. CONT PCB’s ver-
sion
x.x
Life Counter Life Counter Printing the total usage.
xxxxx.x(km)
Head Counter1
Head Counter2/3
Head counter 1, 2,
3
Printing the total usage of print head.
xxxxx.x(km)
Dispenser Counter Dispenser Counter Printing the dispenser usage.
xxxxx.x(km)
Head dot density Model
12 dot/mm HR212
24 dot/mm HR224