SATO HR2 Series - Page 84

Section 3: Operation and Configuration
Page 3-44 HR2 Series Operator Manual
3.13 TEST PRINT MODE (Cont’d)
2)Second page --
Item name (Print) Item name Description
FROM1 CHECK SUM Firmware’s check-
sum
Printing the checksum value in firmware area and
CODE39 barcode.
(A) xxxx (B) xxxx
(P) xxxx (E) xxxx
(K) xxxx
Checksum value differs depending on firmware version.
LAN MAC Address LAN MAC Address xx:xx:xx:xx:xx:xx
Item name (Print) Item name Description
Head-Check [All] Head check result Performing head check and printing out its result.
Head check OK: OK
Head check NG: NG
(NG will be highlighted)
F-Pitch Offset(VR) Factory Pitch Off-
set
Printing the factory pitch offset.
x.xx(mm)
Priority Setting Priority Setting Printing the configuration of system setting commands.
Command / Internal
Total Counter Display Total Counter Dis-
play
Printing display type of total print quantity.
Prints “On” when display.
Prints “Off” when doesn’t display.
LCD Brightness LCD Brightness Printing LCD brightness setting.
00~32
Reprint Reprint Printing reprint ON/OFF.
When reprint is enabled, “ON” will be printed.
When reprint is disabled, “Off” will be printed.
Pitch
Offset
Backfeed
Print start position
Print stop position
Backfeed amount
Printing pitch position, offset position and backfeed value
for each sensor type.
+xx(dot)
+xx(dot)
+xx(dot)
Label Size Label Size Printing the label size set in the printer.
(P)xxxx x (W)xxxx(dot)
TearOff Offset Tear Off Pitch Printing the offset for the first label in Tear off operation.
+x.xx(mm)
DSW Dip switch setting ON/OFF