SATO HR2 Series - Basic Connections

Section 2: Installation
HR2 Series Operator Manual Page 2-17
2.6 BASIC CONNECTIONS
This section explains the power cable and interface cable connection procedures.
2.6.1 Connecting the Interface board
HR2 Series printers are equipped with three different types of standard interface to perform data
communication with the host. These are described as follows.
• USB interface
• LAN interface
• RS-232C (High-speed) interface
Connect interface cable from the printer to the host computer. Use the cable that is compatible with the
standard of the interface board as stated in Section 7: Interface Specifications. Make sure the cable is
correctly oriented before you insert it.
Caution
• Never connect or disconnect interface cables (or use a switch box) with power applied to either
the host or printer. This may caused damage to the interface circuitry in the printer/ host and is
not covered by warranty.
Host
RS232C
USB
LAN