Section 2: Installation
Page 2-16 HR2 Series Operator Manual
2.5 REMOVING THE CARBON RIBBON (cont’d)
4.
Push the wound-up carbon ribbon to the right side of the
rewind shaft bearing to remove the ribbon rewind shaft
assembly.
Caution:
Be careful when removing the carbon ribbon, your hands
may get dirty while handling it.
5. Remove the empty core from the ribbon supply shaft in
the same manner.
Note:
Don’t dispose of the empty ribbon core after removing it from the ribbon supply shaft. Instead, transfer it to
the ribbon rewind shaft so that used ribbon can be wound around it after a new ribbon roll has been
loaded.
To Next Page
Loading...
