SATO HR2 Series - Base Reference Point Adjustment; Adjustment of Print Position

Section 8: Appendix
HR2 Series Operator Manual Page 8-5
8.4 BASE REFERENCE POINT ADJUSTMENT
The offset function (print and stop) of the printer are as follows.
8.4.1 Adjustment of Print Position
Label stop position (print position) is adjustable within the range of +3.75mm to -3.75mm (+0.15" to -0.15")
due to the above settings on LCD screen.
Note
The above base position for printing will be the stop position when the GAP sensor is selected.
Adjustments
Base Position for Printing Setup on LCD
Adjustment mode: PITCH/ Test Print
mode: PITCH POSITION
+3.75mm to -3.75mm
(+0.15" to -0.15")
-3.75mm (-0.15”)
Label feed direction
Base reference
point for printing
(Print head)
Adjustment for
“+” value
No
Adjustment
Adjustment for
“-” value
Pitch sensor
+3.75mm (+0.15”)
I-Mark:75.88mm (3”)
GAP:39.02mm (1.5”)