Section 2: Installation
HR2 Series Operator Manual Page 2-15
2.5 REMOVING THE CARBON RIBBON
After the carbon ribbon has used up to the end of the roll, remove the wound-up carbon ribbon from the
printer.
1. With the power supply is off, lift up the top cover and
release the ribbon unit by pressing the ribbon lever.
2. Hold two corners of the pinch roller unit to unlatch it.
3. Lift up the ribbon pinch lever.
Caution
• When replacing carbon ribbon, bear in mind that the print head and its surrounding area
remain hot. Keep your fingers away from these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
To Next Page
Loading...
