SATO HR2 Series - Backfeed Offset Adjustment in Service Mode

Section 3: Operation and Configuration
Page 3-62 HR2 Series Operator Manual
3.16 SERVICE MODE (Cont’d)
3.16.4 Backfeed Offset adjustment in Service Mode
1. When BACKFEED is selected, press the FEED button repeatedly will switch to the next setting options as
shown above. To return to the previous setting option, press LINE button. To return to SERVICE MODE
screen, press and hold LINE button.
2. When the desired setting option is displayed, press + / - buttons to set the value and then press FEED but-
ton to save the setting.
Select BACKFEED + FEED
button
FEED button
Return to SERVICE MODE menu
LINE button
+
-
+
-
FEED button
LINE button
+
+
+
FEED button
LINE button
FEED button
LINE button
FEED button
LINE button
-
-
-
* Press <, >, + or - button to select
item or set the value accordingly.
The active icons are displayed on
the screen.
* Press and hold LINE button on each
screen will revert to SERVICE
MODE menu.
%$&.)(('