SATO HR2 Series User Manual

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-63
3.16 SERVICE MODE (Cont’d)
BACKFEED OFFSET MODE
Menu Description
Adjusting the backfeed value for four GAP sensors. The number beside GAP
shows the position of the GAP sensor, ascending from the center to the right of
the printer.
Use + / - buttons to change the value.
“+”: Increases backfeed value.
“-”: Decreases backfeed value.
Setting range is ±0 - 72dot.
The default setting is “+00dot”.
Press FEED to proceed to each GAP sensor to complete the settings.
Adjusting backfeed value for I-MARK sensor.
Use + / - buttons to change the value.
“+”: Increases backfeed value.
“-”: Decreases backfeed value.
Setting range is ±0 - 72dot.
The default setting is “+00dot”.
Press FEED to save the setting and return to service mode menu.
+
-
+
-

SATO HR2 Series Specifications

General

Brand	SATO
Model	HR2 Series
Category	Printer
Language	English