SATO HR2 Series - Upload Mode

Section 3: Operation and Configuration
Page 3-70 HR2 Series Operator Manual
3.18 UPLOAD MODE
This upload feature allows the operator to upload data (firmware, font/logo, True type font, SEMBL,
configuration, status5 log), from the printer and write to the SD card. When uploading is complete, the LCD
screen will return to the original display after three seconds. If an error occurs, error message will display and
identify the reason.
CAUTION:
• Do not turn the power on/off while uploading. This may damage the SD card.
Press FEED, <, > buttons
+ Switch Power to On “ I ”
・ If there is no data for the item selected on the UPLOAD SELECT
screen, nothing will be uploaded.
・ Selecting ALL will upload all the items on the UPLOAD SELECT
screen.
・ Screen messages are displayed in English regardless of the setting
value on the SELECT LANGUAGE screen.
Upload
completed?
Yes
No
Reading the data
Writing the data
Finished receivng the uploaded data
Finished writing the uploaded data
FEED button
FEED button
3 short beeps sound is heard
when the upload is completed