Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-71
3.18 UPLOAD MODE (Cont’d)
Preparation:
Load the SD card to the printer.
1. Make sure the Power of the printer is turned off (O).
2. While pressing the FEED, <and > arrow buttons simultaneously, switch the Power to On (I).
3. The printer enters UPLOAD SELECT screen. Select the desired item and press FEED button.
DOWNLOAD MODE
Menu Description
Selecting the item to be uploaded.
FIRMWARE: Uploading “Firmware”, “Kanji font”, “Kanji outline font”.
KANJI FONT: Uploading “Kanji font”, “Kanji outline font”.
SEMBL: SEMBL program data
CONFIG: Printer configuration
FONT/LOGO: Font/ Logo data
STS5 LOG: Status5 log
ALL: All
The initial setting is FIRMWARE.
Reading in the data for upload.
The gauge shown on the lower portion of screen indicates data reception sta-
tus.
After receiving the data, it goes to WRITING… screen.
Writing the data for upload.
The gauge shown on the lower portion of screen indicates writing status of the
data.
Completion of upload.
Emitting three short beeps when program upload is completed. Press FEED
button to go back to UPLOAD SELECT screen.
To Next Page
Loading...
