SATO HR2 Series - Folder Configuration

Section 2: Installation
HR2 Series Operator Manual Page 2-23
2.7 CONNECTIONS OF OPTIONAL ACCESSORIES (cont’d)
Folder Configuration
The following is the folder architecture inside the SD card to be used for the printer.
DATA
PROG
FONT
Firmware
Firmware : PRG41_XX.BIN (XX : Reg. No. 01 to 03)
SEMBL Program㸸SEMBL.BIN
Data for memory card command
Form overlay registration 㸸SBPLXXXX.OVL (XXXX : Reg. No.0001 to 0099)
Format registration : SBPLXXXX.FMT (XXXX : Reg. No. 0001 to 0999)
Graphic registration: SBPLXXXX.IMG (XXXX : Reg. No. 0001 to 0999)
BMP file registration  : SBPLXXXX.BMP (XXXX : Reg. No. 0001 to 0999)
PCX file registration  : SBPLXXXX.PCX (XXXX : Reg. No. 0001 to 0999)
Memory card 16x16 Extended character registration : SBPL16.BMF
Memory card 24x24 Extended character registration : SBPL24.BMF
PR41
SD card route
Download font / log
Download font data : USRFONTX.DAT(X : Reg. No. (1 to 6))
CONF
Printer configuration information
Printer configuration information file : PRN41.INI
RAS
Rasterized font
No corresponding files for HA200R/HR200
LOG
Maintenance
Receive buffer: RCVBUF.DAT
STATUS5 log : HISTSTS5.DAT
FRAM dump:FRAMDMP.DAT