Section 2: Installation
Page 2-22 HR2 Series Operator Manual
2.7 CONNECTIONS OF OPTIONAL ACCESSORIES (cont’d)
1.
Insert the SD card with the orientation as shown in the pic-
ture.
2. To seat the SD card in the slot, press it in until it makes a
slight clicking sound and it is completely inside the printer.
3. To remove the SD card from the printer, it is best to switch
off the printer. Then, with your finger, press the card edge a
slight amount to release the card from the slot. The slot will
immediately release the card.
Note:
Do not remove the SD card while the printer is accessing the
data in the SD card. Doing so may result in data corruption.
To Next Page
Loading...
