SATO HR2 Series - Table of Default Settings

Section 3: Operation and Configuration
Page 3-52 HR2 Series Operator Manual
3.14 DEFAULT SETTING MODE (Cont’d)
3.14.1 Table of Default Settings
DEFAULT SETTING MODE
Menu Description
DEFAULT ALT. PROTOCOL confirmation menu.
Selecting YES and pressing FEED button will initialize protocol code.
The initial setting is NO.
If NO, it goes to DEFAULT MODE without initializing protocol code.
This screen shows the completion of initialization and three beeps sound is
heard.
After this message is shown, power off the printer.
Item
Default value
HR212 HR224
ADJUSTMENT MODE
PRINT SPEED 2.0 IPS
PRINT DARKNESS 3
DARKNESS RANGE A
PRIORITY SETTING COMMAND
PITCH
+0.00 mm
OFFSET
+0.00 mm
PRINT DARKNESS
50
USER MODE
PRINT SPEED 2.0 IPS
PRINT DARKNESS 3
PRINT OFFSET V:+0000 H:+0000 dot
ZERO SLASH NO
CHARACTER CODE JIS CODE(NEC font/Ryobi font(0208))
SHIFT JIS (Ryobi font (0213))
CHARACTER PITCH FIXED
INTERFACE MODE
KEYPAD CONNECT ENABLE
DATA PORT LAN
SUB PORT NONE
EXTERNAL DEVICE ENABLE
RS-232C CONFIGURATION Priority on selected interface settings
BAUDRATE 19200bps
PARITY BIT NONE
STOP BIT 1 BIT
CHARACTER BIT 8 BIT
LAN CONFIGURATION Priority on selected interface settings
IP RESOLUTION DHCP
RARP SETTING DISABLE
IP ADDRESS 0.0.0.0
SUBNET MASK 0.0.0.0
GATEWAY ADDRESS 0.0.0.0
PORT NUMBER 1 1024