Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-53
3.14 DEFAULT SETTING MODE (Cont’d)
3.14.1 Table of Default Settings (Cont’d)
Item
Default value
HR212 HR224
LAN CONFIGURATION Priority on selected interface settings
PORT NUMBER 2 1025
PROTOCOL STATUS4
STATUS REPLY TIMING ENQ
RECEIVE BUFFER MULTI
ITEM NO CHECK DISABLE
BCC CHECK DISABLE
ADVANCED MODE
DARKNESS RANGE A
PRINT TYPE DISPENSER
BACKFEED MOTION AFTER
SENSOR TYPE GAP
GAP POSITION GAP2
COMMAND ERROR DISPLAY NO
HEAD CHECK ENABLE(NORMAL)
EXTERNAL SIGNAL DISABLE
EXTERNAL SIGNAL TYPE TYPE 4
EXTERNAL REPRINT DISABLE
EXTERNAL DISP COMPLETE DISABLE
AUTO ONLINE YES
AUTO ONLINE FEED YES
FEED ON ERROR YES
SELECT LANGUAGE ENGLISH
PROTOCOL CODE STANDARD
LCD POWER SAVING MODE SETTING 00 MIN
SEMBL MODE AUTO START NO
To Next Page
Loading...
