Section 3: Operation and Configuration
Page 3-54 HR2 Series Operator Manual
3.14 DEFAULT SETTING MODE (Cont’d)
3.14.1 Table of Default Settings (Cont’d)
Items
Default value
HR212 HR224
SERVICE MODE
SENSOR LEVEL (GAP1) 50
SLICE LEVEL (GAP1) Auto setting
SENSOR LEVEL (GAP2) 50
SLICE LEVEL (GAP2) Auto setting
SENSOR LEVEL (GAP3) 50
SLICE LEVEL (GAP3) Auto setting
SENSOR LEVEL (GAP4) 50
SLICE LEVEL (GAP4) Auto setting
SENSOR LEVEL (I-MARK) 50
SLICE LEVEL (I-MARK) Auto setting
PITCH (GAP1) +00 dot
PITCH (GAP2) +00 dot
PITCH (GAP3) +00 dot
PITCH (GAP4) +00 dot
PITCH (I-MARK) +00 dot
OFFSET (GAP1) +00 dot
OFFSET (GAP2) +00 dot
OFFSET (GAP3) +00 dot
OFFSET (GAP4) +00 dot
OFFSET (I-MARK) +00 dot
BACKFEED (GAP1) +00 dot
BACKFEED (GAP2) +00 dot
BACKFEED (GAP3) +00 dot
BACKFEED (GAP4) +00 dot
BACKFEED (I-MARK) +00 dot
PRIORITY SETTING COMMAND
SET PASSWORD OFF
TOTAL QTY DISPLAY YES
REPRINT NO
EXTERNAL DISP PIN SELECT 9PIN
FACTORY MODE
LIFE COUNTER 0
HEAD COUNTER 0
DISPENSER COUNTER 0
OTHERS
TEAR OFF TOP POS +0.00 mm
To Next Page
Loading...
