Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-45
3.13 TEST PRINT MODE (Cont’d)
3)Third page --
Item name (Print) Item name Description
Print Speed Print Speed 1.0 ~ 4.0 (inch/s)
Print Darkness Print Darkness/
Range
Printing the print darkness and darkness range.
1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B
Print Offset Print Offset Printing the offset position for printing.
For 12dot/mm: (H)±2400 (V)±672(dot)
For 24dot/mm: (H)±4800 (V)±1344(dot)
Zero Slash Zero slashing set-
ting
Zero with a slash through it: ON
Zero without a slash: Off
Character Code Character code
setting
JIS code: JIS
SJIS code: SJIS
Unicode: Unicode
Character Pitch Proportional pitch
setting
Proportional pitch: Proportional
Fixed pitch: Fixed
Operation Mode Operation mode
setting
Printing the name of selected operation mode.
Continuous mode: Continuous
Dispense mode: Dispense
Tear-off mode: Tear Off
Backfeed Action Backfeed motion
setting
After printing (Motion 1): Action1
Before printing (Motion 2): Action2
No backfeed motion: None
Head Check Head Check set-
ting
When head check is disabled: None
When head check is enabled:
Checking actual print area: Normal
Checking barcode print area: Barcode
Auto Online Auto Online Yes/No
Initial Feed Initial Feed Enabled/Disabled
Online Feed Feed on error Enabled/Disabled
Command Error Command Error Printing the command error setting.
Prints Error: when enabled.
Prints Warning: when disabled.
LCD Power Saving LCD Power Saving Printing the transition time of LCD power save mode in
minutes.
xx (min)
Protocol Code Protocol code set-
ting
Standard code: Standard
Non-standard code: Non-Standard
Also, the protocol code set for the printer will be printed
out.
STX:xxH, ETX:xxH, ESC:xxH, ENQ:xxH,
CAN:xxH, NULL:xxH, OFFLINE:xxH
To Next Page
Loading...
