SATO HR2 Series - Page 86

Section 3: Operation and Configuration
Page 3-46 HR2 Series Operator Manual
3.13 TEST PRINT MODE (Cont’d)
4)Forth page --
Item name (Print) Item name Description
Pitch(LCD) Print position
adjustment value
Printing the pitch position set through LCD screen.
±3.75(mm)
Offset(LCD) Stop position
adjustment value
Printing the offset position set through LCD screen.
±3.75(mm)
Darkness(LCD) Darkness adjust-
ment value
Printing the print darkness set through LCD screen
00~99
EXT Signal EXT Signal setting Printing external signal setting.
Enabled: Enabled
Prints TYPE1, TYPE2, TYPE3 or TYPE4 according to
selected external signal type.
Disabled: Disabled
EXT Signal(Dis-
penser)
EXT Signal(Dis-
penser) setting
Printing setting of dispense completion signal.
Enabled: Enabled
Disabled: Disabled
Doesn’t print when [EXT SIGNAL] is DISABLE.
EXT Signal(Reprint) EXT Sig-
nal(Reprint) setting
Printing reprint setting.
Enabled: Enabled
Disabled: Disabled
Item name (Print) Item name Description
Keypad Keypad Printing setting of Keypad connection
Enabled: Enabled
Disabled: Disabled
Data Port Data Port LAN / RS-232C / USB
Sub Port Sub Port None / RS-232C / USB / LAN
Interface display
LAN
Protocol Protocol setting STATUS3
STATUS4 (ENQ)
STATUS4 (CYC)
STATUS5
Item No. Check
(When STATUS5 is
selected)
Item No. check set-
ting
ENABLE / DISABLE
BCC Check
(When STATUS5 is
selected)
BCC check setting ENABLE / DISABLE
RARP setting RARP setting ENABLE / DISABLE