SATO HR2 Series - Page 87

Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-47
3.13 TEST PRINT MODE (Cont’d)
Item name (Print) Item name Description
STATUS REPLY TIM-
ING
(When STATUS4 or
STATUS5 is selected)
IP address ENQ / CYCLE
IP Address IP address xxx.xxx.xxx.xxx
Subnet Mask Subnet mask xxx.xxx.xxx.xxx
Gateway Address Default gateway xxx.xxx.xxx.xxx
DHCP/RARP DHCP/RARP set-
ting
ENABLE / DISABLE
Port 1/2 LAN port number 1
and 2
xxxxx
RS-232C
Protocol Protocol setting READY/BUSY
XON/XOFF
STATUS2
STATUS3
STATUS4
STATUS5
Item No. Check
(When STATUS5 is
selected)
Item No. check set-
ting
ENABLE / DISABLE
BCC Check
(When STATUS5 is
selected)
BCC check setting ENABLE / DISABLE
Receive Buffer Receive buffer type MULTI / 1ITEM
Baudrate Baud rate setting 2400 / 4800 / 9600 / 19200 / 38400 /
57600 / 115200(bps)
Parity Parity setting NONE / ODD / EVEN
Data Bit Data length setting 7 / 8 (BIT)
Stop Bit Stop bit setting 1BIT / 2BIT
USB
Protocol Protocol setting STATUS4
STATUS5
Item No. Check
(When STATUS5 is
selected)
Item No. check set-
ting
ENABLE / DISABLE
BCC Check
(When STATUS5 is
selected)
BCC check setting ENABLE / DISABLE