Section 3: Operation and Configuration
HR2 Series Operator Manual Page 3-19
3.7 INTERFACE MODE (Cont’d)
LAN CONFIGURATION
Menu Description
This screen allows user to select from setting of IP address manually or using
DHCP to assign IP address automatically.
MANUAL: Perform IP addresses settings manually.
Select MANUAL and press FEED button will proceed directly to RARP setting.
DHCP: Allows DHCP to assign unique IP addresses automatically.
Select DHCP and press FEED button will continue to PORT NUMBER setting.
The initial cursor position is at DHCP.
Note: Changed settings will be in effect from the next power on.
Set RARP (Reverse Address Resolution Protocol) function.
ENABLE: RARP is activate and request to learn the IP address from the
server.
DISABLE: RARP is disabled and proceed to IP ADDRESS screen for manual
input.
The initial setting is DISABLE.
Note: Changed settings will be in effect from the next power on.
Setting the IP address, follow by the Subnet mask and then Gateway address
of LAN.
Press +/- buttons to change the setting value and press , arrow buttons to
move the cursor to next digit.
Press FEED button to save the setting.
The initial setting is " 0. 0. 0. 0".
Note: Changed settings will be in effect from the next power on.
Setting the Port number 1, 2 of LAN.
Press +/- buttons to change the setting value and press , arrow buttons to
move the cursor to next digit.
Press FEED button to save the setting.
Setting range is between 00000 and 65535. The initial value for Port number 1
is 01024, Port number 2 is 01025.
Note: Changed settings will be in effect from the next power on.
To Next Page
Loading...
