Section 3: Operation and Configuration
Page 3-20 HR2 Series Operator Manual
3.7 INTERFACE MODE (Cont’d)
LAN CONFIGURATION
Menu Description
Select the communication protocol.
STATUS3, STATUS4 and STATUS5 are available for selection when LAN inter-
face boards are installed.
The initial value is STATUS4.
When STATUS3 is selected, the printer will proceed directly to INTERFACE
MODE menu or EXTERNAL DEVICE screen.
When STATUS4 is selected, the printer will proceed to STATUS REPLY TIM-
ING menu.
When STATUS5 is selected, the printer will proceed to ITEM NO CHECK
menu.
Set item number check function.
ENABLE: Item number check is ON
DISABLE: Item number check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set BCC check function.
ENABLE: BCC check is ON
DISABLE: BCC check is OFF
The initial value is DISABLE.
This screen is displayed only when PROTOCOL is set to STATUS5.
Set status reply timing to the host.
ENQ: Returns status after receiving Status Request (ENQ), which was sent
from the host
CYCLE: Returns status from the printer to the host at 500ms intervals
The initial value is CYCLE.
This screen is displayed only when PROTOCOL is set to STATUS4.
To Next Page
Loading...
